Oneway ONE3016 # 1 Profiled Spigot Jaws For The Talon Chuck Specialty Clamps when placed in the hole

when placed in the hole

and added wear resistance

Shop Setting CFM*: 2450

three sturdy plastic dividers and two removable plastic bins

Overall Length: 3-3/8"

Oneway ONE3016 # 1 Profiled Spigot Jaws For The Talon Chuck Specialty Clamps when placed in the holeThey are machined long and deep for better grip on smaller parts. The outside surface of the jaws is serrated to grip the work piece. These jaws are called the #1 Jaws for the Talon Chuck, but can also be referred to as spigot jaws. Important These jaws are not to be used with the woodworm screw. WEIGHT These jaws weigh approximately lb. JAW CAPACITIES All the measurements below are in INCHES and are accurate to within 1 8". Manufacturer Min Max